Brands
Categories


Categories A-Z
Manufacturers A-Z
Brands A-Z


ENGINE COMPONENTS
FUEL INJECTORS & ACCESSORIES
FUEL PUMPS & ACCESSORIES
HARDWARE
HOSE, FITTINGS, ADAPTERS, ACCESSORIES
LIGHTING SOLUTIONS
PROMOTIONAL ITEMS
TOOLS
VEHICLE ELECTRONICS
WIRE HARNESSES & SOLUTIONS
WIRING COMPONENTS & AIDS


Accufab
Aeromotive
Bosch
Delphi Electronics
Delphi Fueling Products
Delphi Injectors
Denso
Edelbrock
Fragola Performance Systems
Fram
Gates
Goodridge
HBD Industries
Hobbs
Lingenfelter Performance
Littlefuse
More...


Accel
Autofuse
Barricade
FIREFLEX
FLEXO
Fragola
Goodridge
Hobbs
Insultherm
Kyosan
More...



Browse other Categories here:
HOME  FUEL INJECTORS & ACCESSORIES  Fuel Injectors - Low Impedance

  65 lb/hr Delphi Low-Z Fuel Injector    


Click for larger picture
List Price: $57.50
Our Price: $52.61 per EACH
Buy in:
Qty:    Add Item to Cart
Add to Wish List
Item Code: 17113814
Weight: 91.00GM
Brands: Delphi
Manufacturers : Delphi Injectors
Stock: Yes
Model: 17113814FM
Categories: Fuel Injectors - Low Impedance
Retail P/N: 17113814
Manufacturer P/N: 17113814
Static Flow lb/hr (n-Heptane): 65.0
Static Flow cc/min: 718
Dynamic Flow Tolerance +/-%: 5%
Coil Resistance Ohms: 2
Spray Pattern: 24.4 degrees - single spray cone
Connector Type: Minitimer (Bosch EV1)
O-ring Type: Viton
Weight (non-shipping): .20 lbs
Dynamic Flow (gm/sec): 1.53



17113814 (OE 25324744)

 

FLOW-MATCHED 1% INJECTORS ARE SOLD IN PACKS VIA THE 'BUY IN' DROP-DOWN MENU ABOVE.

INJECTORS SOLD AS EACH ARE NOT FLOW-MATCHED (LISTED FACTORY TOLERANCE APPLIES)

TECHNICAL INFORMATION

Dynamically flowed and grouped to within 1% tolerance using Racetronix custom injector flow bench when purchased in packs.
All tests run with n-Heptane @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar), 14VDC (+/-0.05VDC), saturated driver with RC cutoff.

Injector flow rates are based on testing with n-Heptane test solvent (0.6855 g/ml). U.S. EPA emission test gasoline 40CFR86.113 (0.735g/ml) flows in most common injector designs at about a 3 to 4% higher rate than n-Heptane. A ratio of 1.035:1 can be used when converting the flow specifications above.

This low-impedance injector is designed to work with peak and hold injector drivers typically found in aftermarket ECM/PCMs as well as dedicated injector driver modules sold by Racetronix..

TYPICAL APPLICATIONS

High-performance aftermarket

ADDITIONAL INFORMATION

  • Grease supplied to lubricate o-rings prior to installation
 



Wish List
 




©Racetronix, All rights reserved.
Mail us at: Please visit www.racetronix.com/contact