FLOW-MATCHED 1% INJECTORS
ARE SOLD IN PACKS
VIA THE 'BUY IN' DROP-DOWN MENU ABOVE.
INJECTORS SOLD AS EACH
ARE NOT FLOW-MATCHED
(LISTED FACTORY TOLERANCE APPLIES)
Dynamically flowed and grouped to within 1% tolerance using Racetronix
custom injector flow bench when purchased in packs.
tests run with n-Heptane @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar), 14VDC
(+/-0.05VDC), saturated driver with RC cutoff.
Injector flow rates are based on testing with n-Heptane test solvent (0.6855
g/ml). U.S. EPA emission test gasoline 40CFR86.113 (0.735g/ml) flows in
most common injector designs at about a 3 to 4% higher rate than n-Heptane.
A ratio of 1.035:1 can be used when converting the flow specifications
This low-impedance injector is designed to work with peak and hold injector drivers typically found in aftermarket ECM/PCMs as well as dedicated injector driver modules sold by Racetronix. We do not recommend the use of resistor / ballast boxes with these injectors which will void your warranty..