G7 In-tank & Intermediate Harness Kit
BCWA-G77 - DISCONTINUED
The external harness in this kit is designed to replace
the factory bulkhead connector and wiring assembly on 1984-1987 Turbo Buicks and many other
GM vehicles which have a 3-wire connector assembly. This external 24" harness has a 3-position Delphi WeatherPack connector which is wired as follows: A - GROUND - BLACK The in-tank pin-outs are as follows: C - GROUND This harness features: - Upgraded 14 gauge automotive-grade TXL
wire When this harness is used in combination
with our upgraded in-tank harnesses the overall resistance is reduced from
approximately 0.085 to 0.026 ohms. Some vehicles may have different WeatherPack keying or designations. Alternative connectors and / or pin-outs can be special ordered. ******** The yellow bulkhead connector is OE equipment
and has been pressure tested, fitted with an o-ring seal and supplied with
a new SS press-on retaining clip. ******** There are two types of in-tank harnesses available to be purchased with this bulkhead assembly. This kit comes bundled with the following:
This in-tank harnesses are designed to be used with our BCWA-G7 Bulkhead Wire and Connector Assembly above. These harnesses feature: - Heavy-duty gas-safe Teflon wire Some senders may have different in-tank wiring configurations however the in-tank connector's terminals can be re-arranged to match with a simple paper clip provided. * Performance based on load tests simulating 60 PSI operating pressure at 13.5V in combination with manufacturer's published pump voltage vs. flow charts. Harness resistance tests were conducted with sustained 10, 15 and 20 amp loads measured between the WeatherPack connector and the pump's in-tank supply terminals. |