0
Welcome to Racetronix  |  All prices indicated are in USD($)  905-477-7014  |   Help Center  |  Catalogs  |  About Us

72 lb/hr Low-Z Injector

Item #: 01D140x

$51.75

$57.50

per EACH

$230.00

 per  4 Pack

$345.00

 per  6 Pack

$460.00

 per  8 Pack

$575.00

 per  10 Pack
This is an obsolete Item
 
 
 In Stock & Ready to Ship

01D140x - 72 lb/hr Low Impedance Fuel Injector


TYPICAL APPLICATIONS:

  • High-performance aftermarket
TECHNICAL INFORMATION

Dynamically flowed and grouped to within 1% tolerance using Racetronix custom injector flow bench when purchased in packs.

All tests run with n-Heptane @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar), 14VDC (+/-0.05VDC), saturated driver with RC cutoff.

Injector flow rates are based on testing with n-Heptane test solvent (0.6855 g/ml). U.S. EPA emission test gasoline 40CFR86.113 (0.735g/ml) flows in most common injector designs at about a 3 to 4% higher rate than n-Heptane. A ratio of 1.035:1 can be used when converting the flow specifications above.

This low-impedance injector is designed to work with peak and hold injector drivers typically found in aftermarket ECM/PCMs as well as dedicated injector driver modules sold by Racetronix..

ADDITIONAL INFORMATION
  • Grease supplied to lubricate o-rings prior to installation

FLOW-MATCHED 1% INJECTORS ARE SOLD IN PACKS VIA THE 'BUY IN' DROP-DOWN MENU ABOVE.

INJECTORS SOLD AS EACH ARE NOT FLOW-MATCHED (LISTED FACTORY TOLERANCE APPLIES)

Static Flow lb/hr (n-Heptane): 69
Static Flow Tolerance +/-%: 4%
Dynamic Flow (mg/pulse): 16.74
Dynamic Flow Tolerance +/-%: 4%
Coil Resistance Ohms: 2.2
Coil Resistance Tolerance +/- Ohms: 0.15
Peak/Hold Current Amps: 4A / 1A
Spray Pattern: Tri-Cone
Connector Type: Minitimer