17113814 (OE 25324744) - 65 lb/hr Delphi Low-Z Fuel Injector
TYPICAL APPLICATIONS:
- High-performance aftermarket
Dynamically flowed and grouped to within 1% tolerance using Racetronix
custom injector flow bench when purchased in packs.
All
tests run with n-Heptane @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar), 14VDC
(+/-0.05VDC), saturated driver with RC cutoff.
Injector flow rates are based on testing with n-Heptane test solvent (0.6855
g/ml). U.S. EPA emission test gasoline 40CFR86.113 (0.735g/ml) flows in
most common injector designs at about a 3 to 4% higher rate than n-Heptane.
A ratio of 1.035:1 can be used when converting the flow specifications
above.
This low-impedance injector is designed to work with peak and hold injector drivers typically found in aftermarket ECM/PCMs as well as dedicated injector driver modules sold by Racetronix..
- Grease supplied to lubricate
o-rings prior to installation

INJECTORS SOLD AS EACH ARE NOT FLOW-MATCHED (LISTED FACTORY TOLERANCE APPLIES)

Retail P/N: | 17113814 |
MPN - Manufacturer P/N: | 17113814 |
Static Flow lb/hr (n-Heptane): | 65.0 |
Static Flow cc/min: | 718 |
Dynamic Flow Tolerance +/-%: | 5% |
Coil Resistance Ohms: | 2 |
Spray Pattern: | 24.4 degrees - single spray cone |
Connector Type: | Minitimer (Bosch EV1) |
O-ring Type: | Viton |
Weight (non-shipping): | .20 lbs |
Dynamic Flow (gm/sec): | 1.53 |